3/31/2023 0 Comments Power suite 2008HUD: A Heads-Up Display (HUD) is built into the visor.Gun compartments located in the lower leg sections.Enhanced protection, but can still be penetrated by a needle gun.Grav-boots may provide an alternative though. Gravity Generation: The suit is compatible with gravity accelerators for use on space platforms.Aural Directional Enhancers: Help clarify the source of external and transmitted sounds.The suit's visor is made of a clear, durable material named plexithene. While the user's fingers do not slip into the suit's fingers, a haptic feedback system ensures precise control (in theory). The user's hand is located between the suit's wrist and fingers. Control of the suit is done through an operator interface within the gauntlets. Segmented plates support the arm joints and spine. These "afterburners," as they are commonly known, vent the heat generated by the suit's power supply, and the temperature buildup in harsh atmospheric conditions. These tubes make up the bulk of an efficient liquid cooling system, assisted by a twin set of high-speed turbines. These run through the jointed areas of the suit, protecting wires and distributing coolant. The upper back section of the suit houses a series of rubber tubes. Many marines noted that this armor would be significantly more comfortable compared to their later counterparts. The suit's motors are also located in the chest, powering the servos that allow for the suit's enhanced movement. These reactors have an operational failure rate of less than 0.5% in the field, a figure so impressive that it's regularly attributed to divine providence. The suit is powered by cold fusion cartridges that are inserted into the suit's chest. Old Confederate-era CMC-300's continue to be issued to some Dominion garrisons after the Brood War. The CMC-300 weighs several hundred pounds and adds a foot to the wearer's height. It was already in service by 2478 and was standard issue to marines during the Great War. The CMC-300 Powered Combat Suit is the much improved successor to the CMC-200. The CMC-230 XF was the flame trooper version of the XE, and was nicknamed the "firebat." After its cancellation, a non-jump capable version of the latter was retained for Confederate military use. Hank Harnack after seeing a CMC-230 XF in use ( src) The CMC-225 was the standard powered armor used by the Terran Confederacy during the Guild Wars. In addition, the suit is compatible with stimpacks, which are able to be installed under the arms. Basic NBC (nuclear/biological/chemical) shielding.Seven day endurance on internal recycling alone.A needle gun can penetrate the suit, however. Salvage System: Should the suit's arm or leg be breached, the suit seals it off in a tourniquet.adjusts itself to fit a firing stance, improving the gunner's aim). Structural support (supports the user's body, e.g.Shoulder housed ammunition reloads and sensor arrays.Green, yellow and presumably red feature, keeping the user informed of the suit's integrity. Visor System: Lights flicker on the interior of the visor's rim acting as a basic guide.Air conditioner (a "backpack" which channels heat away from the body). The CMC-200 is known to have the following features: By 2478 it was being phased out by its successor, the CMC-300 and was considered obsolete by the Guild Wars, only being used for training. The CMC-200 Powered Combat Suit was used in the 25th century. These models were effectively replaced by CMC Powered Combat Suits, though some were still in use during the Great War. "assault armor") was issued some time before the CMC-300 and -400 series became prevalent. Information has been kept general where possible, though distinctions have had to be made when there are specific differences. Note: Multiple aesthetics exist for the same versions of the CMC suit, which at times contradict each other. A more involved method consisted of the suit being constructed from prefabricated parts around the user, seemingly sealing the user inside. Some suits allowed the helmet and surrounding segments to be removed and replaced, allowing a user to simply climb in through the opening. Įasier methods were available after the Brood War, at the latest. Constant drills allowed early members of the Sons of Korhal to complete the task in just one minute. Depending on a suit's material state and the user's experience it could take three to twenty minutes to suit up. The size and bulk of some types of armor before and during the Great War required frequent training to don efficiently. Tychus Findlay just prior to being sealed in CMC armor
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |